About us
Products
Quality
Safety
Contact

 
Safety

Recommendations for the use of cutting and grinding wheels
 
In order to obtain the best results from the use of the cutting and grinding wheels as well as to avoid accidents during use ( breaking of the wheel, vibrations) it is necessary to know the directions for use:


respect the prescriptions of the quality certificates, the value of rotations per minute shown on the label as MAXIMUM work speed – this value must not be exceeded

pay attention to the color bar on the label
-Yellow 60 m/s
- Red 100m/s

use only wheels that are appropriate to the machine as the diameter of the wheels is imposed by the characteristics of the machine, respectively the correlated diameter of the case;

do not mount the abrasive wheels on the machine without the tightening flanges; use only the original flanges;

respect the tolerance of maximum 0.5 mm between the diameter of the bore-hole of the wheel and the diameter of the shaft of the machine. Thus, the breaking (due to this reason) or the vibrations during use will be avoided;

the penetration of the material will be made in the direction of the rotation of the wheel; drive the wheel straight on the cutting direction;

do not press during cutting. The weight of the machine is enough;

do not grind with cutting wheels;


Follow the pictograms and the use restrictions printed on the label
 
   
Use googles.
Use dust mask.
Use safety headphones.
Use protective gloves.
Read the directions for use.
Use for grinding.
Grinding wheel.
Do not use for grinding.
Cutting wheel.
Use for metal/steel.
Use for stone.
   
  All LMD products are manufactured and tested in compliance with the European Standard “En-12413 – Safety requirements
for bonded abrasive products”.



Site map   Terms and conditions   Contact